Be sure to have the PIQ Receivers (WASP) setup before proceeding with the next step, as if the PIQ Receivers (WASP) are not installed properly the PIQ system will not respond.

NOTES:

Bikes must be ANT + compatible for the bikes to pair up with the system.
You may want to number the bikes prior to the setup as this will make it less confusing when setting up the bikes with the PIQ System.

1. Click on Admin Panel (F)

2. Click on Bike Pairing (B)

3. Turn on the Bike Console with the RPM and Power values showing

NOTE: It is recommended to turn each bike console on one at a time so it reduces the errors.

4. Now pedal the bike for a few seconds. The bike should appear on the PIQ Configure Bike screen, like below.

5. Next, select the bike number (A) and then click Set (B) if you need to change a bike number click on Reset (C)

6. Now repeat steps 45 for the rest of the bikes. When you are all finished setting up the bikes click close.

Congratulations you successfully paired up your bikes to the PIQ System.