 |
Knowledge Base |
P I Q System - Receiver Setup
|
In
these instructions, you will learn how to set up your PIQ receivers (WASP).
NOTE: It is recommended to set up each receiver one at a time, as this will cause issues with the installation later on.
1. Plug in your receiver into the laptop via USB cable
2. Open up the PIQ software program
3. Click on Admin Panel
4. Click on Wireless Receivers
5. Click on USB setup (A)
6. You will get a screen like below:
7. Congratulations! You have set up your wasp receiver.
NOTE: It is recommended to set up each receiver one at a time, as this will cause issues with the installation later on.
1. Plug in your receiver into the laptop via USB cable
2. Open up the PIQ software program
3. Click on Admin Panel
4. Click on Wireless Receivers
5. Click on USB setup (A)
6. You will get a screen like below:
- Select your Wi-Fi network. Click on Rescan Wifi Networks (B) if you do not see your network.
- Once you clicked on your Wi-Fi network, enter the password in the password field (C)
- Once you are finished click on Save receivers settings" (D)
7. Congratulations! You have set up your wasp receiver.
    |